How to remove the bounce water outlet of the wash basin?

When installing the wash basin, pay attention to the installation of accessories such as the sewer pipe. How to remove the bounce water outlet on the wash basin? Let's take everyone to understand it together.

The bounce sink of the wash basin is sometimes blocked, especially when hair falls into it and hangs on the drainage net, which will cause blockage over time. In this case, you can first lift the bounce cover upwards, then rotate it counterclockwise, and the bounce cover will fall off. Then use tweezers to clamp out the hair and other debris inside, and then tighten the bounce cover clockwise, and it can be used normally.

If the sewer is seriously blocked, unscrewing the bounce cover will not solve the problem. You can see that under the sink, there is a nut that firmly covers the sewer pipe. It is as thick as the sewer pipe and has six edges and corners. Unscrew it with your hands or a wrench, and the entire sewer pipe is removed. Then rinse with clean water, clean the dirt inside, and install it back. To prevent water leakage during installation, you can first apply some silicone glue on the bottom of the washbasin, then install and tighten the drain pipe, and it can be used after 24 hours.

If you require high-quality plumbing supplies and dependable installation kits, try XIN GE LING. Their well-designed, long-lasting solutions make this type of plumbing project simpler and more efficient.Visit our website at www.tzxgl.com to learn more about our products. For inquiries, you can reach us at 1291395273@qq.com.